LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1997 >> Wrangler SE, Automatic >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Vehicle Communications System >> Testing >> Test 4A - Bus Short To Battery

Test 4A - Bus Short To Battery

NOTE: Perform TEST VER-1A  after each repair.
CAUTION: Always turn ignition off prior to disconnecting any module connector.
  1. Turn ignition off. Disconnect Powertrain Control Module (PCM). PCM is located at right corner of firewall. Turn ignition on. If scan tool does not display BUS SHORT TO BATTERY, go to TEST 4B. If scan tool displays BUS SHORT TO BATTERY, go to next step.
  2. Turn ignition off. Disconnect instrument cluster. Turn ignition on. If scan tool does not display BUS SHORT TO BATTERY, replace instrument cluster. If scan tool displays BUS SHORT TO BATTERY, go to next step.
  3. Turn ignition off and wait 5 minutes. Disconnect Air Bag System Control Module (ABSCM). ABSCM is located under center console. Turn ignition on. If scan tool does not display BUS SHORT TO BATTERY, replace ABSCM. If scan tool displays BUS SHORT TO BATTERY, go to next step.
  4. Disconnect scan tool from DLC. Using external voltmeter, measure voltage between ground and terminal No. 3 (Violet/Brown wire) on DLC connector. If voltage is more than .2 volt, repair Violet/Brown wire for short to voltage. If voltage is .2 volt or less, go to next step.
  5. Measure voltage between ground and terminal No. 11 (White/Black wire) on DLC connector. If voltage is more than .2 volt, repair White/Black wire for short to voltage. If voltage is less than .2 volt, replace scan tool cable or scan tool as necessary.
scientia non olet · About LEMON Manuals