Power Mirror Motor Test
- Remove door trim panel. See POWER MIRROR ASSEMBLY under REMOVAL & INSTALLATION. Disconnect power mirror 8-pin connector from door module. Connect jumper wire to ground.
- Connect second jumper wire to 12-volt power source. Connect each jumper wire as indicated in POWER MIRROR MOTOR TEST . See Fig 1 . If mirror does not function as specified, replace power mirror.
POWER MIRROR MOTOR TEST
| Connect 12 Volts To Terminal | Connect Ground To Terminal | Mirror Reaction |
|---|---|---|
| "A" | "G" | Left |
| "G" | "A" | Right |
| "H" | "G" | Up |
| "G" | "H" | Down |