Test 10B - No Response From Radio
Turn ignition off. Disconnect radio Gray connector. Using scan tool in ohmmeter mode, measure resistance on terminal No. 6 (Red/Gray wire). If resistance is less than 5 ohms, repair Red/Gray wire for short to ground. Replace fuse No. 1. If resistance is 5 ohms or greater, replace radio. Replace fuse No. 1.
NOTE:
For connector terminal ID, see CONNECTOR IDENTIFICATION
and WIRING DIAGRAM. Perform VERIFICATION TEST VER-1 after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.