Test TC-157D- Intermittent Loss Of CMP Or CKP
NOTE:
Perform TEST TC-157A before proceeding. For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY. For component location see wiring diagram in the WIRING DIAGRAMS
article.
- Inspect CKP sensor for proper installation. Correct CKP sensor installation if necessary. If CKP sensor is properly installed, go to next step.
- Remove CKP sensor. Inspect flywheel for damage. Repair flywheel as necessary and perform TEST VER-2A. If flywheel is okay, replace CKP sensor and perform TEST VER-2A.
- Remove CKP sensor. Inspect crankshaft for damage or misalignment. Repair crankshaft as necessary. If crankshaft is okay, replace CKP sensor and perform TEST VER-2A.
NOTE:
A break in test sequence occurs at this point. Sequence skips from TEST TC-157D to TEST TC-160A. No tests have been omitted.