Test 1A - Identifying Vehicle Equipment & System Problems
CAUTION:
Always turn ignition off prior to disconnecting or connecting any module connector.
NOTE:
Perform TEST VER-1B after each repair.
- Connect scan tool to Chrysler Collision Detection (CCD) Data Link Connector (DLC). DLC is located behind fuse access cover. If scan tool screen is blank, go to TEST 108A . If scan tool screen is not blank, go to next step.
- Turn ignition on. Using scan tool, select BODY SYSTEM, then BODY COMPUTER. If scan tool does not display BUS OPERATIONAL, see VEHICLE COMMUNICATION TESTS in this article. If scan tool displays BUS OPERATIONAL, go to next step.
- If scan tool displays NO RESPONSE, go to TEST 106A . If scan tool does not display NO RESPONSE, go to next step.
- Using scan tool, read Diagnostic Trouble Codes (DTCs). If scan tool does not display DTCs, see DIAGNOSTIC TEST DIRECTORY table below for specific diagnosis. If scan tool displays DTCs, go to TEST 1B .
DIAGNOSTIC TEST DIRECTORY (1)
| Problem/Message | Perform Test | ||
|---|---|---|---|
| Chime System | TEST 2A | ||
| Compass/Mini-Trip Module | TEST 15A | ||
| Courtesy Lamp System | TEST 21A | ||
| Electronic Instrument Cluster (EIC) | TEST 30A | ||
| Electro/Mechanical Instrument Cluster (MIC) | TEST 42A | ||
| Headlamp Time Delay System | TEST 57A | ||
| Illuminated Entry System | TEST 60A | ||
| Key-In Lamp | TEST 63A | ||
| Liftgate Release | TEST 66A | ||
| Power Door Lock System | TEST 69A | ||
| Infinity Radio (CCD) | TEST 86A | ||
| Seat Belt Warning Lamp | TEST 92A | ||
| Side Door Memory Lock | TEST 95A | ||
| Windshield Wiper System | TEST 96A | ||
|
|||