LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1995 >> Grand Cherokee Laredo, 4.0 S, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls - Remove/Install/Overhaul - 5.2L) >> Ignition System >> Distributor >> Installation

Ignition System: Distributor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Position distributor in engine. Ensure "O" ring is properly seated on distributor. Replace "O" ring if cracked or nicked. Carefully engage distributor driven gear with camshaft drive gear so when distributor is installed properly, rotor aligns with reference mark.
  2. Install distributor cap. Check all high tension wires for good connections. Install hold-down nut. Connect camshaft position sensor wiring harness connector.
scientia non olet · About LEMON Manuals