LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1995 >> Cherokee Country, 4WD, Part Time, Standard >> Repair and Diagnosis >> Electrical >> Charging Systems >> Generator >> On-Vehicle Testing >> DRB Test Functions >> DRB Volt/Ohmmeter Mode

DRB Volt/Ohmmeter Mode

To access volt/ohmmeter mode of DRB, connect Red volt/ohmmeter test lead to Red port, located on right-top side of DRB.

NOTE: Because DRB is grounded through data link connector, only one volt/ohmmeter test lead is required when using volt/ohmmeter option.

To access voltmeter, press VOLT/OHM key once. DRB is now in voltmeter mode. Touch test probe to connector or wire to be measured. Read voltage on DRB display. When voltage testing is complete, press VOLT/OHM key 3 times to exit voltmeter mode.

To access ohmmeter, press VOLT/OHM key twice. DRB is now in ohmmeter mode. Touch test probe to connector or wire to be measured. Read resistance to circuit ground on DRB display. When resistance testing is complete, press VOLT/OHM key twice to exit ohmmeter mode.

scientia non olet · About LEMON Manuals