LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1994 >> Wrangler Renegade, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Distributor >> Installation

Ignition System: Distributor: Installation

  1. Position distributor in engine. Ensure "O" ring is properly seated on distributor. Replace "O" ring if cracked or nicked. Carefully engage distributor driven gear with camshaft drive gear so when distributor is installed properly, rotor aligns with reference mark.
  2. Install distributor cap. Check all high tension wires for good connections. Install hold-down nut. Connect camshaft position sensor wiring harness connector.
scientia non olet · About LEMON Manuals