Test 12A - Repairing Door Switch Lock Sense Circuit
NOTE:
For connector terminal identification, refer to CONNECTOR IDENTIFICATION
. For wiring diagrams, see WIRING DIAGRAM
.
NOTE:
Perform TEST 1A
before proceeding with TEST 12A.
- Ensure power doors locks are functioning properly. Repair door locks that are not functioning properly. Turn ignition off. Disconnect VTA module. See Figure in TEST 1A and see VEHICLE THEFT ALARM MODULE under REMOVAL & INSTALLATION. Inspect connector, clean and repair as needed and go to next step.
- Using DRB in voltmeter mode, check voltage at VTA module connector terminal No. 15 (Orange/Violet wire). While measuring voltage, push power lock switch to LOCK position and hold. If voltage is more than 10 volts, replace VTA module. See VEHICLE THEFT ALARM MODULE under REMOVAL & INSTALLATION. Perform TEST VER-1 . If voltage is less than 10 volts, repair open lock switch LOCK sense circuit (Orange/Violet wire). Perform TEST VER-1 .