Crankshaft Position Sensor: Installation
WARNING: This page is about a different car, the 1994 Plymouth Voyager, 1994 Plymouth Grand Voyager, 1994 Dodge Grand Caravan, and 1994 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.
If reinstalling removed sensor, clean off old spacer from sensor face. New spacer must be attached to sensor face before installation. Install sensor in transaxle, and push sensor down until it contacts drive plate. Hold sensor in position, and install retaining bolt. Connect sensor connector to wiring harness connector.
NOTE:
On some models, it may not be necessary to remove all components listed.