LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1993 >> Grand Cherokee Base, 5.2 Y, AWD >> Repair and Diagnosis >> Body & Frame >> Power Windows >> System Tests >> Test A: No Windows Operate

Test A: No Windows Operate

  1. Measure voltage at power window feed connector at fuse panel. If battery voltage exists, go to next step. If battery voltage does not exist, replace 60-amp fuse in Power Distribution Center (PDC).
  2. Turn ignition switch to OFF position and measure resistance from driver's side kick panel to ground. If resistance is zero ohms, go to next step. If resistance is not zero ohms, repair open to ground.
  3. Remove master door lock/power windows switch assembly mounting screws. Measure resistance between ground and driver's side switch connector terminal No. 1 (Black wire). If resistance is zero ohms, go to next step. If resistance is not zero ohms, repair open to ground.
  4. Turn ignition switch to RUN position and measure voltage at driver's side switch connector terminal No. 5. If battery voltage exists, go to next step. If battery voltage does not exist, repair open to circuit breaker.
  5. Operate window switch, if window moves up and down, system is okay at this time. If window does not move up or down, test switch for continuity in each position. See COMPONENT TESTS  . If switch tests okay, replace defective motor(s).
scientia non olet · About LEMON Manuals