LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1992 >> Wrangler Base, 2.5 P >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel >> Testing >> Wrangler >> Oil Pressure Sending Unit

Oil Pressure Sending Unit

  1. Turn ignition switch to RUN position. Disconnect oil pressure sending unit connector from oil pressure sending unit. Touch connector to ground. Gauge should read at low end of scale. When connector is not touching ground, gauge should read at high end of scale. If gauge is okay, replace sending unit.
  2. If gauge is not okay, check circuit between sending unit and gauge for an open circuit. If wiring is okay, replace gauge.
scientia non olet · About LEMON Manuals