LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1992 >> Cherokee Limited >> Repair and Diagnosis >> Electrical >> Charging Systems >> Alternator & Regulator >> Testing (On-Vehicle) >> DRB-II Test Functions >> DRB-II Volt/Ohmmeter Mode

DRB-II Volt/Ohmmeter Mode

To access volt/ohmmeter mode of DRB-II, connect Red volt/ohmmeter test lead to Red port, located on right-top side of DRB-II.

NOTE: Because DRB-II is grounded through engine diagnostic connector, only one volt/ohmmeter test lead is required when using volt/ohmmeter option.

To access voltmeter, press VOLT/OHM key once. DRB-II is now in voltmeter mode. Touch test probe to connector or wire to be measured. Read voltage on DRB-II display. When voltage testing is complete, press VOLT/OHM key 3 times to exit voltmeter mode.

To access ohmmeter, press VOLT/OHM key twice. DRB-II is now in ohmmeter mode. Touch test probe to connector or wire to be measured. Read resistance to circuit ground on DRB-II display. When resistance testing is complete, press VOLT/OHM key twice to exit ohmmeter mode.

scientia non olet · About LEMON Manuals