Window Regulator: Removal
- Remove interior door latch release assembly and control panel retaining screws. Disconnect control linkage and wire harness connector. Remove latch release and control panel assembly. Remove armrest retaining screws.
- Swing armrest downward to a vertical position and disconnect from upper retainer clip. Pull armrest straight out from trim panel. Starting at the bottom, remove trim panel using a wide flat blade tool.
- Remove plastic sheet, door glass attaching stud nut and spring washer. Pull glass upward and out of door. Disconnect wire harness connector from window regulator. Remove window regulator rivets by grinding off the heads and knocking them out with a punch. See Figure .