Turning Angle Adjustment

The turning angle stop screws are located on back side of steering knuckle, just above axle centerline. To adjust, loosen lock nut on stop screw.
Using full-floating turn table under each wheel, adjust stop screw IN to increase turning angle and OUT to decrease turning angle. Tighten lock nut.

TURNING ANGLE ADJUSTMENT

Application

Left Wheel

Right Wheel

Cherokee, Comanche Wagoneer & Wrangler ⁽¹⁾

32-33°

⁽¹⁾	This angle may be reduced to allow 1/2" (13 mm) minimum clearance between front sway bar bracket and tire at full turn.