All V8 Models: Installation
Clean all gasket surfaces, install new hoses (as required) and gaskets. Reverse removal procedure, tighten nuts and bolts, adjust drive belt tension and refill cooling system.
CAUTION:
Check to be sure wire coil is installed in lower radiator hose. Failure to install this coil will result in the nose collapsing at high engine RPM.
TIGHTENING SPECIFICATIONS
| Application | Ft. Lbs. | |
|---|---|---|
| Water Pump-to-Block | ||
| 151" Engines | 22-28 | |
| 258" Engines | 9-18 | |
| All V8 Engines | 18-33 | |
| Water Pump-to-Timing Cover | ||
| V8 Engines Only | 3-5 | |
| Fan Blade-to-Hub | ||
| All Models | 12-25 | |
| Thermostat Housing | ||
| 151" Engines | 20 | |
| All Others | 10-18 | |