LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1969 >> Commando 2.2L Eng >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering Pumps - >> Overhaul >> Disassembly

Power Steering Pumps -: Overhaul: Disassembly

  1. Remove outlet fitting and identification tag from pump. Invert pump assembly, and remove pump reservoir and seal using a soft-faced hammer. Again invert assembly, loosen and remove pump housing attaching hardware, and remove pump housing.
  2. If necessary, remove housing cover, "O" ring seal, and pressure springs. Remove and discard pump cover gasket. Remove retainer end plate and upper pressure plate. Remove loose fitting dowel pin.
    CAUTION: Do not bend fixed dowel pin which remains in housing assembly.
  3. Remove rotor assembly, being careful to prevent springs and slippers from falling out.
    NOTE: Further disassembly is not necessary unless lower pressure plate, housing plate, rotor shaft and/or seal are to be replaced.

    Invert pump and, using suitable puller, remove pump pulley. Clean pulley end of rotor shaft thoroughly, then remove pump rotor shaft. Remove lower pressure plate.

scientia non olet · About LEMON Manuals