Side Object Detection Control Module (G2218880): Installation

WARNING: This page is about a different car, the 2019 Jaguar I-Pace. However, it is still accessible from the selected car via links, so may be relevant.

- Install the side object detection control module.
- Install and tighten the screw.
  Torque: 1.9 Nm
- Install the side object detection control module to the bracket.
- Install and tighten the 2 screws.
  Torque: 1.9 Nm
- Install the side object detection control module assembly.
- Install and tighten the 3 nuts.
  Torque: 1.9 Nm
- Connect the electrical connector.
- Secure the electrical harness.
With assistance, install the rear bumper.
Refer to: REAR BUMPER[G2202024] .
If a new component has been installed, configure the side object detection control module, using the Jaguar Land Rover approved diagnostic equipment.
General Equipment: Jaguar Land Rover diagnostic equipment