LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2022 >> F-Pace Base >> Repair and Diagnosis >> Restraints >> Passive Restraints >> Supplemental Restraint System -- F-Pace/X761 >> Supplementary Restraint System (G2502377) >> Diagnosis And Testing >> Airbag And Safety Belt PRETENSIONER Supplemental Restraint System (G2386178) >> Occupant Classification Sensor Control Module (OCSCM) Existing Module Programming

Occupant Classification Sensor Control Module (OCSCM) Existing Module Programming

NOTE: Do not attempt to install individual components from the Occupant Classification Sensor (OCS) service kit, as they are calibrated to function as a single assembly. The complete service kit consists of foam, occupant classification sensor bladder mat with attached smart digital pressure sensor. The CAN type communication and LIN type communication OCS types are NOT interchangeable. Ensure the correct service kit for the vehicle is being used.
  1. Check the seat and ensure all electrical connectors are secure. Ensure the seat is correctly mounted and fixings are tightened to the correct torque. Refer to: FRONT ROW SEAT - INGENIUM I4 2.0L DIESEL/INGENIUM I4 2.0L DIESEL AJ21/INGENIUM I4 2.0L PETROL/INGENIUM I4 2.0L PETROL - PHEV/TDV6 3.0L DIESEL/V6 S/C 3.0L PETROL
    NOTE: Ensure the vehicle is stationary and on a level surface. The seat must be secure and in an upright position before performing the next step. Failure to do this could induce a DTC.
  2. Connect the Jaguar Land Rover approved diagnostic equipment
  3. Set the ignition to ON and wait 10 seconds. Ensure the SRS warning light is illuminated during the ignition test cycle. The SRS warning light should then extinguish after the 10 seconds to confirm no SRS faults exist
    NOTE: All OCS DTCs will be logged in the RCM.
  4. Wait 5 seconds then set the OCS control module in to security access mode, after going in to an extended diagnostic session
  5. Using the Jaguar Land Rover approved diagnostic equipment, refer to datalogger signals ECU calibration Data #1 Number (0xF124), ECU Delivery Assembly Number (0xF113), ECU Core Assembly Number (0xF111), ECU Strategy Number (0xF188). Make a note of the OCS control module part number to ensure it is the correct part number for the vehicle
  6. Using the Jaguar Land Rover approved diagnostic equipment, check and update the OCS control module to the latest level software. Ensure the ignition is set to OFF and wait at least 5 seconds
  7. Set the ignition to ON and wait at least 125 seconds. This will allow sufficient time for DTCs to log in the RCM if any are present
  8. Using the Jaguar Land Rover approved diagnostic equipment, check for OCS and Restraints Control Module (RCM) DTCs stored in the RCM. If no DTCs are found and no SRS warning light is illuminated, no further action is necessary. If any DTCs are found and/or the SRS warning light is illuminated, refer to the relevant article of the service information and perform the relevant repair actions as necessary. Re-perform this procedure to confirm the repair
scientia non olet · About LEMON Manuals