DTC P18A4-12: Motion/Position Sensor Power Circuit - Circuit short to battery: Action
NOTE:
If this DTC
is set with P18A4-11 the circuit between the differential locking motor sensor and rear differential control module may be broken
After installing a new rear differential control module, differential locking motor or electric differential, clear the DTC s and calibrate the system by performing routine - On Demand Self Test
After installing a new rear differential control module, differential locking motor or electric differential, clear the DTC s and calibrate the system by performing routine - On Demand Self Test
- Refer to the electrical circuit diagrams and check the differential locking motor position sensor power circuit for short circuit to power. Repair the wiring harness as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTC s and perform routine - On Demand Self Test. If the fault persists, install a new differential locking motor
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTC s and perform routine - On Demand Self Test. If the fault persists, install a new rear differential control module