DTC B0082-13: Passenger Seatbelt Load Limiter Deployment Control - Circuit open: Action

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Jaguar XJR, 2017 Jaguar XJ, 2016 Jaguar XJR, 2016 Jaguar XJ, and 2015 Jaguar XJR. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Do not measure the resistance of a deployable device using any other method than that described below.

NOTE: The deployable device connector has a locking plunger (orange tab) which should only fully lock when the two connectors are securely mated, male to female. If the plunger can move to the locked position easily when not mated (ie: using reasonable pressure), then this indicates that the connector is damaged. Install a new wiring harness as necessary.

Using the Jaguar Land Rover approved diagnostic equipment, check datalogger signal - Deployment Control 7 Resistance (0x5B0A). Refer to the applicable System Wiring Diagram(s) and check the passenger seatbelt retractor load limiter circuit for open circuit, high resistance
Disconnect the passenger seatbelt retractor load limiter connector and apply light pressure to the connector plunger. If the plunger moves to the engaged position the connector is damaged. Install a new wiring harness as necessary
Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest