DTC B0005-1A: Collapsible Steering Column Deployment Control - Circuit resistance below threshold: Action
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Jaguar XJR, 2017 Jaguar XJ, 2016 Jaguar XJR, 2016 Jaguar XJ, and 2015 Jaguar XJR. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not measure the resistance of a deployable device using any other method than that described below.
NOTE:
A shorting bar inside the connector (deployable device side) intentionally creates a short circuit until the wiring harness connector is installed AND the plunger is engaged.
- Using the Jaguar Land Rover approved diagnostic equipment, check datalogger signal - Deployment Control 4 Resistance (0x5B07). If the resistance is too low, disconnect and reconnect the steering column collapse actuator connector, ensuring that the connector plunger is correctly engaged. Clear the DTCs and retest.
- Disconnect the steering column collapse actuator connector and apply light pressure to the connector plunger. If the plunger moves to the engaged position the connector is damaged. Install a new wiring harness as necessary.
- Refer to the applicable System Wiring Diagram(s) and check the steering column collapse actuator circuit for short circuit between power and ground.
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest. If the fault persists, install a new steering column collapse actuator.