DTC C0064-64: Roll Rate Sensor - Signal Plausibility Failure: Action

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The sensor is located within/integral to the restraints control module
This DTC can be set if the vehicle is being tested on chassis dyno rollers

Refer to the appropriate System Wiring Diagram(s) and check the roll rate sensor circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair circuit as required
Using the Jaguar Land Rover Approved Diagnostic Equipment, check the restraints control module for related DTCs and refer to the relevant DTC index