P080A-54 Clutch Position Not Learned - Missing calibration: Action
NOTE:
The rear differential control module system runs a self calibration routine every 500Km, if any other rear differential control module fault is present this routine will not run and log P080A. If other rear differential control module related faults are also logged these should be investigated first. P080A will also log if the rear differential control module has been removed and reconnected
- Clear DTCs and carry out the on-demand self test via the 'Monitor DTC' tab on the manufacturer approved diagnostic system
- Clear DTCs, ignition state to off for 5 seconds then retest
- If fault persists, check and install a new rear differential control module as required