DTC U2005-62: Vehicle Speed - Signal compare failure: Action

NOTE:

This DTC may be set when the vehicle is being transported.
This DTC may be set even though no fault condition is present and should be ignored unless the customer has reported a navigation system concern. Clear the DTC and retest. Verify the customer concern prior to diagnosis.

Refer to the applicable SYSTEM WIRING DIAGRAM(S) and check the anti-lock brake system control module power and ground circuits for open circuit, high resistance
sing the manufacturer approved diagnostic system, perform a CAN network integrity test. Refer to the applicable SYSTEM WIRING DIAGRAM(S) and check the high speed CAN bus circuits for short circuit to ground, short circuit to power, open circuit, high resistance
Refer to the relevant section of the service information and test the MOST network
Using the manufacturer approved diagnostic system, check the anti-lock brake system control module for related DTCs and refer to the relevant DTC index. Clear the DTCs and retest