DTC P0810-62: Clutch Position Control Error - Signal compare failure: Action
NOTE:
The position sensor is internal to the rear differential locking motor
- Record then clear any stored DTCs
- Carry out the on-demand self test via the 'Monitor DTC' tab on the manufacturers approve diagnostic system
- Clear DTCs, ignition state to off for 5 seconds, roadtest vehicle, then retest
- If fault persists, carry out the guided diagnostic routine using the manufacturer approved diagnostic system
- Clear DTCs, ignition state to off for 5 seconds then retest
- If fault persists, check and install a new rear differential locking motor as required