LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2013 >> XK Base, 2D Convertible >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Supplemental Restraint System -- XK/X150 >> Supplemental Restraint System >> Passenger Airbag Module >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Install the passenger air bag module.
    • Tighten the Torx bolts to 3 Nm (2 lb.ft).
  2. Install the heater duct.
    • Install the Torx screws.
  3. Connect the passenger air bag module electrical connectors.
  4. Connect the passenger air bag ground cable.
    • Install the Torx bolt and tighten to 6 Nm (4 lb.ft).
  5. Install the instrument panel upper trim.
    • With assistance, align the components.
    • Install the compression limiters.
    • Install and tighten the Torx screws.
  6. Install the in-vehicle temperature sensor.
    • Position the electrical harness.
    • Connect and secure the electrical connector.
    • Install the Torx screw.
  7. Install the instrument cluster.
    • Connect and secure the electrical connectors.
    • Install the screws.
  8. Install the instrument cluster surround.
    • Install the screws.
  9. Install the MOST diagnostic port.
    • Secure the clip.
  10. Install the instrument panel, lower trim panel.
    • Install and secure the diagnostic socket.
    • Align the clips.
    • Install the Torx screws.
    • Install the Torx bolts and tighten to 6 Nm (4 lb.ft).
  11. Install the rheostat switch assembly and align the instrument panel lower trim panel.
    • Secure the switch assembly clips.
    • Connect the switch assembly electrical connector.
  12. Install the glove compartment.
    • Install the lamp assembly.
    • Connect and secure the electrical connectors.
    • Tighten the Torx screws.
  13. Install the passenger side register.
    • Install the Torx screws.
  14. Install the instrument panel passenger side reinforcement trim panel.
    • Align the pegs and secure with the clips.
  15. Install the driver side register trim panel.
    • Install the Torx screws.
  16. Install the instument panel driver's side reinforcement trim panel.
    • Align the pegs and secure with the clips.
  17. NOTE: The Torx screws may not be fitted.

    Carefully install the center register.

    • Install the Torx screws.
  18. Install the navigation system display module.

    For additional information, refer to: Navigation System Display Module (Removal and Installation).

  19. Install the instrument panel.

    For additional information, refer to: Instrument Panel (Removal and Installation).

  20. Connect the battery ground cable and install the cover.

    For additional information, refer to: BATTERY, MOUNTING AND CABLES -- XK/X150 (Specifications).

  21. Connect WDS to the vehicle and configure a new module.
scientia non olet · About LEMON Manuals