B10A2-32: Crash Input - Signal low time < minimum: Action

This DTC is set when the 'airbag deployed' signal supplied by the restraints control module is outside the specification expected by the engine control module
Check the restraints control module for DTCs and refer to the relevant DTC index
If this DTC is logged with U0151-00 & U0151-08, check for fuse failure, restraints control module power and ground circuits for open circuit. Refer to the applicable SYSTEM WIRING DIAGRAM(S) and check CAN harness
If this DTC is logged with U0151-08, or on its own refer to the applicable SYSTEM WIRING DIAGRAM(S) and check restraints control module crash signal circuit for short circuit to ground, short circuit to power, open circuit, high resistance
Check auxiliary junction box for DTCs and refer to the relevant DTC index
Refer to applicable SYSTEM WIRING DIAGRAM(S) and check the supplementary restraints system input circuit for failures. This circuit is a single wire which connects the restraints control module to the auxiliary junction box and the engine control module. Check this circuit for short circuit to power, short circuit to ground, open circuit. Repair harness as required
Using the manufacturer approved diagnostic system clear all stored DTCs using the `Diagnosis Menu' tab and retest