LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XKR 2D Coupe >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Supplemental Restraint System >> Supplemental Restraint System >> Removal And Installation >> Roll Over Protection Unit >> Installation

Roll Over Protection Unit: Installation

  1. Install the roll over protection unit.
    • Tighten the Torx bolts to 25 Nm (18 lb.ft).
    • Connect the electrical connector.
  2. Install the rear seat backrest retaining bracket.
    • Tighten the nuts and bolts to 10 Nm (7 lb.ft).
  3. Install the rear seat backrest trim panel.
    • Tighten the bolts to 10 Nm (7 lb.ft).
    • Install the clips.
  4. Install the rear seat backrest. Refer to Rear Seat Backrest information.
  5. Connect the battery ground cable and install the cover. Refer to SPECIFICATIONS information.
  6. Connect WDS to the vehicle and configure a new module.
scientia non olet · About LEMON Manuals