Driver Seat Module: Notes

A memory store switch is located in the lower part of the driver door. The switch communicates with the DSM module via the LIN bus in the driver seat switchpack. The memory store switch has two switches; 1 and 2 to allow two separate memory positions to be stored and 'set' switch with integral LED (light emitting diode). Steering Column is controlled by the IC, hence positional feedback goes to the IC. Door mirrors are controlled by the door modules, therefore their positional feedback goes to the door modules.

Once the driver seat, steering column and exterior mirrors have been adjusted, the vehicle is able to memorize these settings for future use by using the following procedure:

• Push the memory 'SET' switch, the LED in the switch will illuminate
• Press the memory switch 1 or 2 to memorize the current settings. The LED will extinguish, and a chime will sound to confirm that the settings have been memorized. If the ignition is on, power mode 6, the message center will display a confirmation message.

The positions can be recalled by pressing the applicable switch 1 or 2.