LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2009 >> XK8 2D Convertible >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> Starting System (4.2L) >> Start Control Unit - Removal and Installation >> Removal

Start Control Unit - Removal and Installation: Removal

  1. Remove the rear seat armrest. Refer to Rear Seat Armrest article.
  2. Remove the floor console veneer trim panel. Refer to Floor Console Finish Panel article.
    GJ0009282Courtesy of JAGUAR CARS, INC.
  3. Remove the floor console rear panel.
    • Carefully release the 2 clips.
    GJ0009283Courtesy of JAGUAR CARS, INC.
  4. Remove the floor console side panel trim.
    • Remove the 2 Torx bolts.
    • Carefully release 11 clips.
    • Repeat the procedure and remove the opposite hand.
    GJ0009296Courtesy of JAGUAR CARS, INC.
  5. Remove the keyless start control module trim cover.
    • Remove the 2 Torx screws.
    GJ0009993Courtesy of JAGUAR CARS, INC.
  6. Remove the keyless start control module.
    • Remove the 2 Torx screws.
    • Disconnect the electrical connector.
scientia non olet · About LEMON Manuals