LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2009 >> XK8 2D Convertible >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> MULTIFUNCTION Electronic Modules >> Multifunction Electronic Modules >> Remote Keyless Entry (RKE) Module - Removal and Installation >> Removal

Remote Keyless Entry (RKE) Module - Removal and Installation: Removal

NOTE: This module is installed on the inside of the RH A-pillar above the footwell and does not change with the hand of drive.
  1. Remove the cover and disconnect the battery ground cable. Refer to Specifications article.
    GJ0009595Courtesy of JAGUAR CARS, INC.
    2. CAUTION: Removal of the clips is a delicate procedure, damage will occur if any force is used.
  2. Remove the RH side footwell trim panel.
    • Remove the 3 clips.
    GJ0009596Courtesy of JAGUAR CARS, INC.
  3. Remove the keyless entry module.
    • Remove the 2 Torx screws.
    • Disconnect the 5 electrical connectors.
scientia non olet · About LEMON Manuals