LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2007 >> XKR 2D Convertible >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Automatic Transmission/Transaxle External Controls >> Automatic Transmission/Transaxle External Controls (4.2L) >> Selector Lever - Removal and Installation >> Installation

Selector Lever - Removal and Installation: Installation

  1. Install the gear selector assembly.
    • Position the electrical harness.
    • Install the Torx bolts and tighten to 6 Nm (4 lb.ft).
    • Connect the selector cable ball joint.
  2. Connect the gear selector assembly electrical connector.
  3. Install the LH side floor console electrical harness connector blocks.
    • Carefully align and secure the clips.
  4. Install the floor console side panel trim.
    • Carefully align and secure the clips.
    • Tighten the Torx screws to 6 Nm (4 lb.ft).
    • Install the opposite hand.
  5. Install the floor console rear panel.
    • Align the lugs and secure the clips.
  6. Install the floor console veneer trim panel. Refer to Floor Console Finish Panel article.
  7. Install the rear seat armrest. Refer to Rear Seat Armrest article.
scientia non olet · About LEMON Manuals