LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2007 >> XJ8 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Roof Opening Panel) >> Removal and Installation >> Roof Opening Panel Module >> Installation

Roof Opening Panel Module: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 Jaguar XJR, 2003 Jaguar XJ8, 2003 Jaguar XJ, 2002 Jaguar XJR, and 2002 Jaguar XJ8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Synchronize control module gears. Refer to MOTOR SYNCHRONIZATION  .
  2. Exercising care to avoid damaging edge, lower front of headlining for access.
  3. Install control module ensuring tang on RH side fully seats.
  4. Connect harness multiplugs to control unit.
  5. Carefully install front edge of headlining.
  6. Position RH sun visor support block and install securing screw.
    7. NOTE: Gearbox slotted boss descends until flush with gearbox casing when drive is re-engaged.
  7. Using a drive key or screwdriver in the motor gearbox slot, manually rotate the spindle 1/4 turn counter-clockwise to re-engage the motor drive.
  8. Install roof console. Refer to OVERHEAD CONSOLE .
  9. Position RH sun visor in support block.
  10. Install sliding roof trim panel.
  11. Connect ground cable to battery terminal and fit battery cover. Refer to BATTERY CONNECT .
  12. Turn ignition switch to position II.
  13. Check for satisfactory operation of sliding roof panel by fully opening and closing twice.
  14. Turn ignition switch to position O.
scientia non olet · About LEMON Manuals