LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2006 >> XJ8 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Supplemental Restraint System) >> Supplemental Restraint System >> Roll Over Protection Unit - Removal and Installation >> Installation

Roll Over Protection Unit - Removal and Installation: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 Jaguar XKR, 2009 Jaguar XK8, 2008 Jaguar XKR, 2008 Jaguar XK8, and 2007 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the roll over protection unit.
    • Tighten the Torx bolts to 25 Nm (18 lb.ft).
    • Connect the electrical connector.
  2. Install the rear seat backrest retaining bracket.
    • Tighten the nuts and bolts to 10 Nm (7 lb.ft).
  3. Install the rear seat backrest trim panel.
    • Tighten the bolts to 10 Nm (7 lb.ft).
    • Install the clips.
  4. Install the rear seat backrest. Refer to Rear Seat Backrest article.
  5. Connect the battery ground cable and install the cover. Refer to Specifications article.
  6. Connect WDS to the vehicle and configure a new module.
scientia non olet · About LEMON Manuals