Section 7 (On Board Diagnostics)
WARNING: This page is about a different variant/trim than selected.
- Introduction
- Diagnostic Trouble Codes
- Mode $06 Data
- 3.1 Functional Description
- Notes
- 3.1.1 Reporting of On-Board Diagnostic Monitor ID test values in response to $06 $00 request
- 3.1.2 Reporting of On-Board Diagnostic Monitor ID test values in response to $06 $01 - $FF request
- 3.1.3 Unit and Scaling ID definition
- 3.1.4 Test Result Description
- 3.1.5 Example for Use of Standardized Test IDs for Misfire Monitor
- 3.1 Functional Description
- Onboard Monitoring
- 4.1 Catalyst Monitoring
- 4.2 Misfire Monitoring
- 4.2.1 Description
- 4.2.2 Strategy Description
- Introduction
- Recording segment time and position, and its manipulation
- Adjustment of crank angle tolerance
- Misfire 'signal' calculation
- Misfire judgement
- Catalyst damage judgement
- Storing adaption values in back-up memory
- Excess emissions judgement
- Monitor execution check
- Adaptive learning execution check
- Rough road and low fuel level judgement
- 4.2.3 Drive Cycle Information
- 4.3 Evaporative Emission System Monitoring
- 4.4 Fuel System Monitoring
- 4.5 Oxygen Sensor Monitoring
- 4.5.1 Upstream Oxygen Sensor High Low Monitor
- 4.5.2 Upstream Oxygen Sensor Slow Response
- 4.5.3 Upstream Oxygen Sensor Slow Activation
- 4.5.4 Downstream Oxygen Sensor High or Low Monitor
- 4.5.5 Downstream Oxygen Sensor Stuck Monitor
- 4.5.6 Downstream Oxygen Sensor Rationality Check
- 4.5.7 Drive Cycle Information
- 4.6 Thermostat Monitoring
- 4.7 Idle Speed Control
- 4.8 Crankshaft Position and Engine Speed Sensor
- 4.9 Camshaft Position Sensors
- 4.10 Engine Coolant Temperature (ECT) Sensor
- 4.11 Manifold Absolute Pressure Sensor
- 4.12 Mass Airflow Sensor
- 4.13 Barometric Pressure Sensor
- 4.14 Fuel Rail Pressure Sensor
- 4.15 Intake Air Temperature Sensor
- 4.16 Engine Oil Temperature Sensor
- 4.17 Fuel Rail Temperature Sensor
- 4.18 Knock Sensor
- 4.19 ECM Power Supplies
- 4.20 Engine Control Module Self Test
- 4.21 Engine Starting
- 4.22 Accelerator Pedal Position Sensor
- 4.23 Throttle Control System
- 4.24 Torque Monitoring
- 4.25 Vehicle Speed Signal
- 4.26 Fuel Injectors
- 4.27 Ignition Amplifiers/Coils
- 4.28 Variable Valve Timing
- 4.29 Cold Start Emission Reduction Strategy
- 4.30 Secondary Air Injection System
- 4.31 Controller Area Network System
- 4.32 Fuel Level Sensor
- 4.33 Engine Off Timer
- 4.34 Ambient Air Temperature
- 4.35 Intake Manifold Tuning Valve System