Position Sensor Monitoring
The TCM can identify errors with the position switch located within the transmission. If an unrecognized position code is read by the TCM a plausibility fault will be logged. (A code is checked between positions).
The position switch outputs a 4-bit code to the TCM, the bits being labelled L1-L4. For the transmission, the following codes are used to identify the selector position.
Only for the automatic side of the J-GATE P,R,N,D
Selector position switch code
| Position | Code | |||
|---|---|---|---|---|
| L1 | L2 | L3 | L4 | |
| Park | 0 | 0 | 1 | 0 |
| Reverse | 0 | 0 | 0 | 1 |
| Neutral | 0 | 1 | 0 | 0 |
| Drive | 1 | 1 | 1 | 0 |