Pinpoint Test S: SLCM POWER SUPPLY OR GROUND FAULT

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Jaguar XKR, 2006 Jaguar XK8, 2005 Jaguar XKR, 2005 Jaguar XK8, and 2004 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.

CHECK THE PERMANENT SUPPLY TO THE SLCM
Disconnect the SLCM electrical connector, BT40.

Measure the voltage between BT40, pin 15 (NW) and GROUND.

Is the voltage less than 10 volts?

YES: REPAIR the circuit between the SLCM and battery. This circuit includes the rear power distribution box, (fuse 10) and the high power protection module. For additional information, refer to the wiring diagrams. Test the system for normal operation.

NO: Go to step 2.
CHECK THE PERMANENT GROUND TO THE SLCM
Measure the resistance between BT40, pin 13 (BK) and GROUND.

Measure the resistance between BT40, pin 14 (BK) and GROUND.

Is either resistance greater than 5 ohms?

YES: REPAIR the high resistance circuit. For additional information, refer to the wiring diagrams. Test the system for normal operation.

NO: Check for DTCs indicating a faulty circuit. Contact dealer technical support for advice on possible SLCM failure