Accelerator Cable: Removal

WARNING: This page is about a different car, the 2002 Jaguar XKR and 2002 Jaguar XK8. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the battery ground cable.
Remove the windshield and wiper arm assembly.
Remove the plenum chamber finisher, Refer to COWL VENT SCREEN .
Disconnect the throttle cable from the electronic throttle assembly quadrant.
- Rotate the throttle quadrant to release the cable. (1)
- Disconnect the throttle cable from the electronic throttle assembly quadrant. (2)
Fig 1: Disconnecting Throttle Cable
Courtesy of JAGUAR CARS, INC.
Displace the outer cable from the abutment bracket.
- Cut the retaining strap. (1)
- Displace the outer cable from the abutment bracket. (2)
Fig 2: Removing Outer Cable From Abutment Bracket
Courtesy of JAGUAR CARS, INC.
Release the grommet from the plenum chamber closing plate and route the cable/grommet through the aperture.

Fig 3: Routing Cable/Grommet Through Aperture
Courtesy of JAGUAR CARS, INC.
Remove the throttle cable from the bulkhead retaining clip.

Fig 4: Removing Throttle Cable From Bulkhead Retaining Clip
Courtesy of JAGUAR CARS, INC.
Route the throttle cable through the water deflector bracket.

Fig 5: Routing Throttle Cable Through Water Deflector Bracket
Courtesy of JAGUAR CARS, INC.
Ensure the drivers seat is fully rearward.
Remove the A-Pillar lower trim pad.
Disconnect the throttle cable from the pedal.
- Remove the throttle cable split pin.
- Remove the throttle cable retaining sleeve.
- Disconnect the throttle cable.
Fig 6: Disconnecting Throttle Cable From Pedal
Courtesy of JAGUAR CARS, INC.
From under the hood, remove the cable from the vehicle.