Visual Inspection Chart
VISUAL INSPECTION
| Electrical |
|---|
| General |
|
| Controller area network (CAN) |
|
| Standard corporate protocol (SCP) |
|
| International standards organization (ISO) |
|
FUSE RATING, LOCATION AND CIRCUIT DESCRIPTION
| Fuse | Rating | Circuit | Location |
|---|---|---|---|
| 04 | 5 Amp, naturally aspirated, 10 Amp supercharged | Engine control module | EMS fuse box |
| 05 | 10 Amp | Engine control module | Engine compartment fuse box |
| 10 | 5 Amp | Engine control module | EMS fuse box |
| 07 | 15 Amp | Body processor module | Left-hand heelboard fuse box |
| 03 | 15 Amp | Body processor module | Right-hand heelboard fuse box |
| 07 | 20 Amp | Body processor module | Right-hand heelboard fuse box |
| 05 | 15 Amp | Body processor module | Left-hand heelboard fuse box |
| 10 | 5 Amp | Restraints control module | Left-hand heelboard fuse box |
| 06 | 5 Amp | Transmission control module (vehicles without supercharger) | EMS fuse box |
| 01 | 10 Amp | Transmission control module (vehicles without supercharger) | Engine compartment fuse box |
| 01 | 10 Amp | Transmission control module (vehicles with supercharger) | Engine compartment fuse box |
| 16 | 10 Amp | J-Gate illumination module | Left-hand heelboard fuse box |
| 18 | 30 Amp | ABS/Traction control module | Engine compartment fuse box |
| 16 | 30 Amp | ABS/Traction control module | Engine compartment fuse box |
| 04 | 5 Amp | ABS/Traction control module | Engine compartment fuse box |
| 20 | 20 Amp | Adaptive damping control module | Luggage compartment fuse box |
| 17 | 10 Amp | Adaptive damping control module | Left-hand heelboard fuse box |
| 06 | 10 Amp | Air conditioning control module | Passenger side fuse box |
| 12 | 10 Amp | Air conditioning control module | Driver side fuse box |
| 18 | 5 Amp | Instrument cluster | Left-hand heelboard fuse box |
| 14 | 10 Amp | Instrument cluster | Left-hand heelboard fuse box |
| 01 | 10 Amp | Security and locking control module | Luggage compartment fuse box |
| 10 | 10 Amp | Security and locking control module | Luggage compartment fuse box |
| 15 | 25 Amp | Driver door control module (right-hand drive vehicles) | Right-hand heelboard fuse box |
| 15 | 25 Amp | Driver door control module (left-hand drive vehicles) | Left-hand heelboard fuse box |
| 15 | 25 Amp | Passenger door control module (right-hand drive vehicles) | Left-hand heelboard fuse box |
| 15 | 25 Amp | Passenger door control module (left-hand drive vehicles) | Right-hand heelboard fuse box |
| 01 | 20 Amp | Driver seat control module (right-hand drive vehicles) | Left-hand heelboard fuse box |
| 01 | 20 Amp | Driver seat control module (left-hand drive vehicles) | Right-hand heelboard fuse box |
| 01 | 20 Amp | Passenger seat control module (right-hand drive vehicles) | Right-hand heelboard fuse box |
| 01 | 20 Amp | Passenger seat control module (left-hand drive vehicles) | Left-hand heelboard fuse box |
| 13 | 25 Amp | Passenger rear door control module (right-hand drive vehicles) | Left-hand heelboard fuse box |
| 13 | 25 Amp | Passenger rear door control module (left-hand drive vehicles) | Right-hand heelboard fuse box |
| 13 | 25 Amp | Driver rear door control module (right-hand drive vehicles) | Right-hand heelboard fuse box |
| 13 | 25 Amp | Driver rear door control module (left-hand drive vehicles) | Left-hand heelboard fuse box |
| 08 | 5 Amp | Key transponder module | Left-hand heelboard fuse box |
| 14 | 10 Amp | Vehicle speed interface module | Left-hand heelboard fuse box |
- Where the Jaguar approved diagnostic system is available, complete the S93 report before clearing any or all fault
codes from the vehicle.NOTE: If a DTC cannot be cleared, then there is a permanent fault present that flags again as soon as it is cleared (the exception to this is P1260, which will only clear following an ignition OFF, wait one minute, ignition ON cycle after rectification).
- If the cause is not visually evident and the Jaguar approved diagnostic system is not available, use a scan tool to retrieve the fault codes before proceeding to the DTC index chart, or the symptom chart if no DTCs are set.CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Each vehicle is configured to it's own vehicle identification data (VID) block, and substitution of control modules may not only not confirm a fault, but may cause faults in the vehicle being tested and/or the donor vehicle.CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.CAUTION: When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00.NOTE: When performing electrical voltage or resistance tests, always use a digital multimeter (DMM) accurate to 3 decimal places, and with an up-to-date calibration certificate. When testing resistance, always take the resistance of the DMM leads into account.NOTE: Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
- If the cause is not visually evident, verify the symptom and refer to the DIAGNOSTIC TROUBLE CODE (DTC) INDEX .