LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 1993 >> XJS 2D Convertible, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Removal And INSTALLTION >> Ignition System Components >> Crankshaft Position Sensor & Timing Ring

Crankshaft Position Sensor & Timing Ring

  1. Locate crankshaft position sensor on front timing cover. Remove clips securing crankshaft position sensor lead. Disconnect crankshaft position sensor lead. Remove sensor and housing as an assembly. Using an Allen wrench, remove sensor from housing. Remove A/C compressor drive belt. Attach Pulley Lock (18G1437/1) to crankshaft pulley. Rotate engine by hand until pulley lock is against crossmember.
  2. Remove crankshaft pulley bolt. Attach Crankshaft Pulley Remover (18G1436) to pulley. Tighten remover center bolt to withdraw pulley. Remove timing ring from crankshaft pulley. To install timing ring and crankshaft position sensor, reverse removal procedure.
scientia non olet · About LEMON Manuals