LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 1992 >> XJS 2D Convertible >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Servicing - A/T >> Adjustments >> Selector Cable >> XJ6

Selector Cable: XJ6

  1. Position vehicle over lift. Open center console, and remove ashtray. Disconnect sport mode switch from harness. Remove console panel and spacers. Position gear selector lever in Neutral. Unscrew front and rear adjustment lock nuts to end of threads.
  2. Raise vehicle. From below vehicle, remove selector cable ball pin-to-selector lever securing nut. Remove ball pin from selector lever. Ensuring selector is in Neutral, install ball pin to selector lever. Tighten selector lever retaining nut to specification. Refer to the TORQUE SPECIFICATIONS  table.
  3. Lower vehicle. Adjust selector cable nuts so selector lever freely engages Neutral position notch. Tighten front and rear lock nuts. Ensure washer tabs are engaged in bracket.
  4. Install console panel and spacers. Install selector. Connect harness to mode switch, and install switch. Install ashtray.
scientia non olet · About LEMON Manuals