LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 1992 >> XJS 2D Convertible >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Crankshaft Sensor (XJS) >> Removal & Installation

Removal & Installation

  1. XJS is equipped with 2 crankshaft sensors. One sensor (flywheel sensor) is located at rear of engine, and other sensor (TDC sensor) is located at lower front part of engine. Disconnect negative battery cable.
  2. Raise and support vehicle. Remove heat shield (if removing flywheel sensor). Disconnect wiring harness connector. Remove sensor retaining bolts and sensor. To install sensor, reverse removal procedure. Ensure sensor wiring harness is routed in its original position.
scientia non olet · About LEMON Manuals