Throttle Switch
- Disconnect battery, remove cross-rods from throttle pulley, and pull connector off throttle switch. Remove 4 nuts and washers securing throttle pulley plate to throttle pedestal and lift plate clear. Loosen 2 screws securing throttle switch. Insert a 0.050" (1.27 mm) feeler gauge between pulley and closed throttle stop.
- Connect ohmmeter between terminals No. 12 and 17 of throttle switch. Turn throttle switch slowly until meter just indicates very high resistance. Tighten 2 screws securing throttle switch. Remove feeler gauge. Ohmmeter should read very low resistance when pulley is against closed stop. Reassemble and adjust throttle linkage, if necessary.