LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2008 >> i-290 Standard >> Repair and Diagnosis >> Body & Frame >> Frames, Subframes & Crossmembers >> Frame And Underbody >> Repair Instructions >> Engine Protection Shield Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Engine Rear Protection Shield
    GM1871958Courtesy of GENERAL MOTORS CORP.
  1. Install the rear shield to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the rear shield bolts (1).

    Tighten:  Tighten the bolts to 75 N.m (55 lb ft).

  3. Install the rear shield bolts (2).

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

    4. Fig 2: View Of Engine Front Protection Shield
    GM1871957Courtesy of GENERAL MOTORS CORP.
  4. Install the front shield to the vehicle.
  5. Install the front shield bolts (1).

    Tighten:  Tighten the bolts to 60 N.m (44 lb ft).

  6. Install the front shield bolts (2).

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

scientia non olet · About LEMON Manuals