LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2008 >> Ascender LS, RWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 4.2L - Introduction (2 Of 2) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Locating Air Filter Housing/Washer Solvent Tank Assembly Components
    GM1361745Courtesy of GENERAL MOTORS CORP.
  1. Install the lower air filter housing/washer solvent tank assembly (2) onto the mounting studs.
  2. Connect the washer pump hoses (3) to the washer pumps.
    3. NOTE: Refer to Fastener Notice .
  3. Install the 2 air cleaner housing/washer solvent tank assembly retaining nuts (1) to the mounting studs.

    Tighten:  Tighten the nuts to 15 N.m (11 lb ft).

    4. Fig 2: View Of Washer Hose & Headlamp Washer Pump
    GM1362808Courtesy of GENERAL MOTORS CORP.
  4. If applicable, Connect the headlamp washer hose to the headlamp washer pump located on the lower air cleaner housing/washer solvent tank.
    5. Fig 3: Locating Electrical Connectors
    GM907812Courtesy of GENERAL MOTORS CORP.
  5. Connect the following electrical connectors:
    • Windshield washer pump (1)
    • Headlamp washer pump (2), if equipped
    • Low solvent level sensor (4)
    • Lift gate washer pump (6), if equipped
  6. Install the washer solvent level sensor wire harness to the wire harness retaining clips (3, 5).
    7. Fig 4: Locating Air Cleaner Components
    GM1361132Courtesy of GENERAL MOTORS CORP.
  7. Install the air inlet duct (5) to the lower air cleaner housing/washer solvent tank assembly (4).
  8. Install the air cleaner element (6) and air outlet duct (3) to the lower air cleaner housing/washer solvent tank assembly.
  9. Install the air cleaner cover/resonator (2). Refer to Air Cleaner Element Replacement .
scientia non olet · About LEMON Manuals