LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 S, Automatic >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Generator Mounting Bolts
    GM1313647Courtesy of GENERAL MOTORS CORP.
  1. Position the generator to the engine.
  2. Install the engine lift bracket. Refer to Engine Lift Bracket Replacement or Engine Lift Bracket Replacement .
    3. NOTE: Refer to Fastener Notice .
  3. Install the generator mounting bolts.

    Tighten:  Tighten the bolts in sequence to 50 N.m (37 lb ft).

    4. Fig 2: View Of Generator Wiring Components
    GM1313641Courtesy of GENERAL MOTORS CORP.
  4. Connect the generator lead (5) to the generator and install the generator output BAT terminal nut (6).

    Tighten:  Tighten the nut to 20 N.m (15 lb ft).

  5. Press the protective boot (4) on to the generator output BAT terminal (2).
  6. Connect the wiring harness connector (1) to the generator.
  7. Raise and support the vehicle only high enough to access the A/C compressor through the wheelhouse. Refer to Lifting and Jacking the Vehicle .
    8. Fig 3: View Of A/C Compressor
    GM1402502Courtesy of GENERAL MOTORS CORP.
  8. Position the A/C compressor (1) to the engine.
  9. Install the A/C compressor mounting bolts (2, 3).

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  10. Attach the A/C compressor electrical connector to the bracket.
  11. Install the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  12. Install the left front wheel. Refer to Tire and Wheel Removal and Installation .
  13. Lower the vehicle.
  14. Install the drive belt. Refer to Drive Belt Replacement or Drive Belt Replacement .
  15. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals