LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 2.9L - Introduction (2 Of 2) >> Repair Instructions >> Heated Oxygen Sensor 1 Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Removing connector position assurance (CPA) retainer
    GM1769037Courtesy of GENERAL MOTORS CORP.
  1. Remove the connector position assurance (CPA) retainer.
  2. Disconnect the engine wiring harness electrical connector (1) from the heated oxygen sensor (HO2S) electrical connector.
  3. Remove the HO2S sensor electrical connector from the camshaft cover.
    4. Fig 2: View Of HO2S
    GM1769039Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Excessive Force and Oxygen Sensor Notice in Cautions and Notices.
  4. Using the J 39194-B  remove the HO2S from the exhaust manifold. See Special Tools .
scientia non olet · About LEMON Manuals