LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 2.9L - Introduction (2 Of 2) >> Repair Instructions >> Knock Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of KS Engine Wiring Harness Connector
    GM1352023Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the KS (1) and the retaining bolt to the engine block, positioning the electrical terminals rearward.

    Tighten:  Tighten the knock sensor (KS) bolt to 25 N.m (18 lb ft).

  2. Connect the engine wiring harness electrical connector (3) to the KS (1).
  3. Install the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals