LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 439 (Cellular System, Entertainment System & Navigation System) >> Repair Instructions >> Electronic Navigation Antenna Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Envoy and 2009 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Navigation Radio Electrical Connector & Cross Beam
    GM1226967Courtesy of GENERAL MOTORS CORP.
  1. Install the antenna module to the vehicle.
  2. Install the screw retaining the antenna module to the cross-car beam (2).
    3. CAUTION: Refer to Fastener Caution .
  3. Tighten the screw.

    Tighten:  Tighten the screw to 2.5 N.m (22 lb in).

  4. Install the I/P assembly. Refer to Instrument Panel Assembly Replacement .
  5. Connect the electrical connector to the navigational radio (1).
  6. Install the navigational radio. Refer to Radio Replacement .
scientia non olet · About LEMON Manuals